Setting The Temperature - Kenwood IC700 Serie Bedienungsanleitung

hints
G
Start on clothes needing the lowest
temperature, then work upwards.
(This lowers the risk of burning
something because an iron switched
from 'hot' to 'cool' takes time to
cool down.)
G
For mixed fibres, eg cotton
polyester G , use the lowest suitable
temperature G .
G
If in doubt, start with a low
temperature on a part that won't be
seen (eg a shirt tail).

setting the temperature

Before switching on the steam
station, make sure that the lock for
continuous steam is in the off
position by firmly pressing the lock
on the left hand side of the iron. This
will ensure that the steam button is
released.
1 Plug the steam station into the
power supply.
2 Switch on, the blue light will glow.
3 Turn the temperature control to the
temperature you want, the light
under the control will glow. When the
iron reaches the set temperature, the
light will go out. (During ironing, this
light will go on and off as your iron
maintains the right temperature.)
dry ironing
Follow the procedure above for
setting the temperature.
Care should be taken not to press
the steam button.
steam ironing
1 Make sure there is water in the tank.
Plug into the power supply and
switch on.
2 Turn the temperature control to the
desired setting. For best results
when steaming we recommend that
the temperature control should be
set to .
3 Wait until the green ready to steam
light glows indicating that the correct
pressure has been reached. This
takes about 3 minutes.
G
During use you may hear a slight
humming coming from the iron. This
means that the pump is operating
GGG and and passing water from the tank to
the boiler where the steam is
generated for ironing. This will be
accompanied by the red low water
indicator light glowing.
4 Before starting to iron press the
steam button several times, this will
release any condensation droplets.
Each time the steam will be forced
through the openings on the iron
soleplate.
5 To produce steam whilst ironing
clothes press the steam button. For
continuous steam, press the steam
button and then press the lock for
continuous steam on the right hand
side of the iron. To stop continuous
steam, press the button on the left
hand side.
When using the steam function, the
green ready to steam indicator light
will go off.
G
It is possible to vary the amount of
steam produced. Move the variable
steam control to the right for
maximum steam and to the left for
minimum steam.
6 The red low water indicator light will
glow continuously when the water
tank becomes empty. This will be
accompanied by a continuous
humming noise of the pump. Should
this occur we recommend you
switch off the steam station. Remove
the water tank and refill.
Note: For prolonged use always
ensure there is water in the water
tank.
4