Outdoor Installation - Bestway LAY-Z-SPA Bedienungsanleitung

water, and users, it is extremely important that the base where
the Lay-Z-Spa is installed is smooth, flat, level and capable of
uniformly supporting the weight for the entire time the Lay-Z-Spa
is installed (not on the carpet or other similar material). If the
Lay-Z-Spa is placed on a surface, which does not meet these
requirements, any damage caused by improper support is not
covered under the manufacturer's warranty. It is the responsibility
of the Lay-Z-Spa owner to assure the integrity of the site at all
times.
1. Indoor Installation:
Be aware of special requirements if you install the spa
indoors.
• Humidity is a natural side effect with Lay-Z-Spa installation.
Determine the effects of airborne moisture on exposed wood,
paper, etc. in the proposed location. To minimize these effects it
is best to provide plenty of ventilation to the selected area. An
architect can help determine if more ventilation is needed.
• Consult your local government authority for installation
regulations.
• Keep suitable air treatment in the spa chamber (ventilation and
dehumidification) regularly to preserve the bathers' safety and
comfort .
• Do not to install the spa on carpet or other floor materials (e.g.
untreated cork, timber or other porous materials) that promote
or harbour moisture and bacteria, or that could be affected by
water treatment chemicals used in the spa.
• Empty the spa before remove it from the chamber or building.

2. Outdoor Installation:

• During filling, draining or when in use, water may flow out of the
spa. Therefore the Lay-Z-Spa should be installed near a floor
drain.
• Do not leave the spa's surface exposed to direct sunlight for
long periods of time.
• Consult your local professional installers for environmental
conditions, such as ground water and risk of frost.
• Recommended to protecting the spa from direct sunlight
exposure by a cover when not in use.
12