Troubleshooting; Possible Cause - Parkside PBS 350 A1 Originalbetriebsanleitung

16. Troubleshooting

Fault
Motor does not work
The motor starts up slowly
and does not reach operating
speed.
Motor makes excessive noise
The motor does not reach its
full power.
Motor overheats easily.
Saw cut is rough or
wavy
Workpiece pulls away
and/or splinters
Saw blade is not running
straight
Burn marks appear on the
wood during the cutting work
Saw blade jams during cut-
ting work
12 GB

Possible cause

Motor, cable or plug defective, fuses
burnt
Housing cover open (limit switch)
Voltage too low, coils damaged,
capacitor burnt
Coils damaged, motor defective
Circuits in the network are overloaded
(lamps other motors, etc.)
Overloading of the motor, insufficient
cooling of the motor
Saw blade dull, tooth shape not appro-
priate for the material thickness
Excessive cutting pressure and/or saw
blade not suitable for use
Guide has been wrongly set
Wrong saw blade
Blunt saw blade
Wrong saw blade
Blunt saw blade
Deposits on the saw blade
Guide has been set poorly
Remedy
Arrange for inspection of the machine by a specialist. Never
repair the motor yourself. Danger! Check fuses and replace as
necessary
Close housing cover exactly
Contact the utility provider to check the voltage.
Arrange for inspection of the motor by a specialist.
Arrange for replacement of the capacitor by a specialist
Arrange for inspection of the motor by a specialist
Do not use any other equipment or motors on the same circuit
Avoid overloading the motor while cutting, remove dust from the
motor in order to ensure optimal cooling of the motor
Resharpen saw blade and/or use suitable saw blade
Insert suitable saw blade
Set the saw blade guide according to the operating instructions
Select a saw blade according to the operating instructions
Change the saw blade
Select a saw blade according to the operating instructions
Change the saw blade
Clean the saw blade
Set the saw blade guide according to the operating instructions