Using The Cd-Rom Drive Pack - Panasonic CF-VCD Serie Bedienungsanleitung

Using the CD-ROM Drive Pack

Installing/Removing a Device
Refer to the Reference Manual included with your computer on how to install/remove the
CD-ROM drive.
Preparations
Windows 2000
Confirm that [Transfer Mode] is set to [DMA if available] in [Start] - [Settings] - [Control
Panel] - [System] - [Hardware] - [Device Manager] - [IDE ATA/ATAPI controllers] -
[Secondary IDE Channel] - [Advanced Settings] - [Device 0]. Perform this setting if it has
E
not yet been made.
Windows XP
Confirm that [Transfer Mode] is set to [DMA if available] in [Start] - [Control Panel] -
[Performance and Maintenance] - [System] - [Hardware] - [Device Manager] - [IDE ATA/
ATAPI controllers] - [Secondary IDE Channel] - [Advanced Settings] - [Device 0]. Per-
form this setting if it has not yet been made.
Windows 98
Confirm the following contents in [Start] - [Settings] - [Control Panel] - [System] - [Device
Manager] - [CDROM] - [TEAC **** ] - [Settings]. Make the settings if they have not yet
been made.
• Add a check mark for [DMA].
• Set both [Start drive letter] and [End drive letter] in [Reserved drive letters] to [L:].
NOTE
<Using PC Cards>
If the PC Card does not work, there may be no interrupt request (IRQ) line available.
Deactivate unnecessary equipment using in Setup Utility.
6