Bestway COOLGROUND X3 Bedienungsanleitung Seite 3

INTRODUCTION
Proper Use
Any use other than that described or any modification of
the product is not permissible and may result in injury
and/or damage to the product. The manufacturer is not
liable for damage caused by improper use. The product is
not intended for commercial use.
Description of parts and features
A
outer tent long pole
1PC 2PCS
C
guy rope peg
6PCS 10PCS
F
carry bag manual
1PC 1PC
Tent Dimensions ：
Outer tent: 210cm x 210cm x 120cm
Pitching dimension: 220cm x 220cm
E W1
L1 L2
WARNING
IMPORTANT SAFETY INSTRUCTIONS
READ AND FOLLOW ALL INSTRUCTIONS
Keep all flames and heat sources away from this tent
fabric. We recommend that you always position your tent
upwind from a camp fire. This will reduce the chances of
having embers land on your tent. In case of fire, please
find the exit to escape from the fire.
Never set up the tent near the river, under the tree of
other objective hazards.
Keep exits clear.
Make sure ventilation openings are open all the time to
avoid suffocation.
SAVE THESE INSTRUCTIONS
303021210596_68088_14x21cm_三人野营帐篷说明书_英
Owner's Manual
Model No.#68088
COOLGROUND 3 Tent
B1 B2
short pole
2PCS
D E
inner tent
1PC
G
W2
H
ASSEMBLY
Setting up the tent
B1
E
FIG1
A
B1
D
B2
E
FIG3
1. Lay the inner tent<E> on the ground. Pull the four
corners outwards.
Note: Make sure that the channels for the poles<B1>
are facing upwards.
Note: Make sure that the zip on the entrance to the
tent is closed.
2. Push the poles<B1> completely into the channels.(FIG1)
3. Stand the inner tent<E> up and push the ends of the
poles<B1> into the iron bars (which are on the each
corner of the inner tent<E>.(FIG2)
4. Fasten the roof of the inner tent<E> onto the pole
junction with the sewn-on tie.(FIG2)
5. Now cover the outer tent<A> and hook the 4 loops.(FIG3)
6. Fit poles<B2>. Support the tent's entrance with the
assembled poles<B2>.(FIG3)
7. Secure the tent by pushing the tent pegs<D> into the
ground loops.(FIG3)
8. Tie one end of the guy ropes<C>onto the four corner
hoops of outer tent<A>.(FIG4)
9. Tie the other end onto the tent pegs<D> and fasten
them by inserting the tent pegs<D> into ground.(FIG4)
10. Note: Ensure that guy ropes<C> are about at an
angle of 45°.
11. Do not pull the guy ropes<C> too tight.
DISASSEMBLE AND MAINTENANCE
Follow steps 1-11 in reverse order.
1. Clean the tent and remove any stains with sponge
and cool water. Please use non-detergent soap for
serious cleaning.
2. Never machine wash or machine dry the tent. Hand
wash and air dry.
3. Please allow all parts to dry thoroughly before you
repack the tent. This will prevent the formation from
mould, bad odours and discoloration
4. Stitch with thread to repair minor leaks, fabrics and
plastic sheets damage. Use ropes to connect broken
frame parts. Use tapes to repair the coating broken
parts.
5. Silicone spray could be use onto zippers if stick.
STORAGE
Store the tent in the stuff sack and place it in a cool, dry
area out of sunlight and away from heat sources and
rodents.
3
B1
FIG2
E
C
45°
FIG4