Celsius/Fahrenheit Toggle - Bestway LAY-Z-SPA Bedienungsanleitung

attached. Air can accumulate inside the spa and cause irreparable
damage to the cover and bodily harm.
NOTE: Heat and massage system work together to create a warm
massage experience.
E/G. TEMPERATURE ADJUSTMENT BUTTONS: Pressing the
Temperature Increase or Decrease buttons will cause the LED to flash.
When it is flashing you can adjust to the desired temperature setting. If
you hold these buttons down the values will rapidly increase or decrease.
The new and desired temperature setting will remain on the LED display
for 3 seconds to confirm the new value.
NOTE: The default temperature is 35°C (95°F).
NOTE: Temperature adjustment ranges from 20°C (68°F) to 40°C
(104°F).
F. ON/OFF BUTTON: Press this button for 2 seconds to active the control
panel buttons and the light turns to green. Press this button for 2 seconds
to turn off all currently activated functions.
H. CELSIUS/FAHRENHEIT TOGGLE: The temperature can be displayed
in either Fahrenheit or Celsius.
I. WATER FILTER BUTTON: This button turns the filter pump on and off.
The light above the Water Filter Button displays red when activated.
J. HYDROJET SYSTEM BUTTON: This button turns the water pump on
and off. The light above the HydroJet system button displays red when
activated.
NOTE: The system will shut off automatically after 1 hour.
NOTE: Do not dry run the HydroJet System.
POWER-SAVING TIMER LED:
This flashing LED means you are setting the heating duration. The light will
be on when the heating function starts to work.
This flashing LED means you are setting the number of hours FROM NOW
when the heater will activate. When the light is on, the Power-Saving
Timer function is set.
NOTE: The WATER HEATER rate may change in the conditions below:
• When the outdoor temperature is below 15°C (59°F).
• If the cover is not in position when the heating function is activated.
NOTE: To display the current water temperature, run the filter system for at least a minute.
The water temperature as tested by an external thermometer may vary from the
temperature as displayed on the spa panel by as much as approximately 2°C.
WINTER USE INSTRUCTIONS
20