Installing The Plastic Wedges; Electrical Connection - Grundig GFN 13720 Bedienungsanleitung

C
3.2 Installing the
plastic wedges
Plastic wedges are used to create
the distance for the air circulation
between the product and the rear
wall. Insert the 2 plastic wedges
onto the rear ventilation cover as
illustrated in the figure. To install
the wedges, remove the screws
on the product and use the screws
given in the same pouch with the
wedges.

3.3 Electrical connection

Connect the product to a grounded
outlet protected by a fuse
complying with the values in the
rating plate. Our company shall
not be liable for any damages that
will arise when the product is used
without grounding in accordance
with the local regulations.
14
Downloaded from www.Manualslib.com
If two coolers are to be
installed side by side,
there should be at least
4 cm distance between
them.
manuals search engine
•
Electrical connection
must comply with national
regulations.
•
Power cable plug must be within
easy reach after installation.
•
The voltage and allowed fuse or
breaker protection are specified
in the Rating Plate which is
affixed to interior of the product.
If the current value of the fuse
or breaker in the house does
not comply with the value in the
rating plate, have a qualified
electrician install a suitable
fuse.
•
The specified voltage must be
equal to your mains voltage.
•
Do not make connections via
extension cables or multi-plugs.
WARNING:
B
power cable must
be replaced by the
Authorised Service
Agents.
WARNING:
product has a failure, it
B
should not be operated
unless it is repaired by
the Authorised Service
Agent! There is the risk
of electric shock!
Damaged
If the