Epson ELPMB48 Bedienungsanleitung Seite 33

Wire clip
Caution
After installing the safety wire, check the following points. If by any chance the wire is damaged,
replace it with a commercially available wire rope of 1.5 mm or more in diameter.
v The wire is not frayed or unraveling.
v The wire is not bent at an acute angle against the edge of the flat washer or
other object.
Caution
v If the supplied safety wires are too short for where you are installing the projector, use
commercially available wire ropes of 1.5 mm or more in diameter.
v Cut off any extra wire rope after installation.
C
Loosen the screws of the wire clip, and then
pass the end of the safety wire through the
wire clip and a hole on the projector plate.
D
Pull the end of the wire rope out from under
the projector plate and pass it through the
wire clip.
E
Stretch the safety wire as tight as possible
without causing the position of the
projected image to move, and then tighten
the screws of the wire clip loosely to secure
the wire.
F
Perform steps 3 to 5 again for other safety
wires and fix them to the projector plate as
well.
G
After installing the safety wires, move all the
wire clips in the direction shown in the
illustration and tighten the screws of the
clips.
33