Adjusting The Length Of The Pole - Epson ELPMB48 Bedienungsanleitung

Adjusting the Length of the Pole

Note
You can hide the gap between the pole and the ceiling surface by attaching the decorative plate
to the pole beforehand. Place the pole through the hole in the decorative plate, and then tighten
the screws on the decorative plate to secure it.
Procedure
26
A
Remove the two fixing bolts using the
supplied M8 hexagon wrench.
B
Remove the four assist-screws on both sides
using the supplied M6 hexagon wrench.
C
There are eight length adjustment holes at 20
mm intervals on the pole. Align the two
appropriate adjustment holes with the holes
for the fixing bolts,and put the two fixing
bolts into the holes and tighten them firmly.
D
Tighten the four assist-screws on both sides
using the supplied M6 hexagon wrench.