Placement Of Speakers; Preparing The Remote Control - Panasonic SA-MAX4000 Bedienungsanleitung

MAX4000E.book Page 4 Tuesday, April 21, 2015 4:57 PM

Placement of speakers

Put the speakers so that the tweeter is on the outside.
Use only the supplied speakers.
You can cause damage to the system and decrease the
sound quality if you use other speakers.
Note:
•
Keep your speakers more than 10 mm from the main unit
for ventilation.
•
Put the speakers on a flat safe surface.
•
More than one person is required to move, tilt or carry the
speakers.
•
These speakers do not have magnetic shielding. Do not put
them near TVs, PCs or other equipment easily influenced
by magnetism.
•
When you play at high levels for a long period, it can cause
damage to the speakers and decrease the life of the
speakers.
• Decrease the volume in these conditions to prevent
damage:
– When the sound is distorted.
–
When you adjust the sound quality.
4
4
CAUTION!
• Use the speakers only with the recommended
system. If not, you can cause damage to the
amplifier and speakers and can cause a fire.
Consult an approved service personnel if damage
Tweeter
occurs or if there is a sudden apparent change in
performance.
• Do not modify the speaker or speaker wires as
this can cause damage to the system.
• Do the procedures included in these instructions
when you attach the speakers.
• Do not touch the speaker cone's reverberating
surfaces:
– This may damage the speaker cone.
– The speaker cone may be hot.
• Be careful when babies or children are near.
• Do not stack the speakers.

Preparing the remote control

Use alkaline or manganese battery.
Install the battery so that the poles (+ and –) align with
those in the remote control.
offset printing