Others; Softwareversion; Maintenance - Panasonic SA-MAX4000 Bedienungsanleitung

MAX4000E.book Page 17 Tuesday, April 21, 2015 4:57 PM

Others

Auto off
This system automatically switches off when you do not
use it for approximately 20 minutes.
1
Press [SETUP] to select "AUTO OFF".
2
Press [Y, U] to select "ON" and then press [OK].
To cancel, select "OFF".
Note:
This function does not work when you are in radio source or
when a Bluetooth ® device is connected.
Bluetooth ® standby
This function automatically switches on the system when
you establish a Bluetooth ® connection from a paired
device.
1
Press [SETUP] to select "BLUETOOTH STANDBY".
2
Press [Y, U] to select "ON" and then press [OK].
To cancel, select "OFF".
Note:
Some devices may take longer to respond. If you are
connected to a Bluetooth device before switching off the
®
system, wait for a minimum of 5 seconds before connecting
to this system from your Bluetooth
Software version
You can check the software version of the system.
1
Press [SETUP] to select "SW VER." and then press
[OK].
The software version is shown.
2
Press [OK] again to exit.

Maintenance

To clean this system, wipe with a soft, dry cloth.
• Never use alcohol, paint thinner or benzine to clean this
• Before using chemically treated cloth, read the
device again.
®
offset printing
system.
instructions that came with the cloth carefully.
17
17