Fitting The Hob Into A Worktop - Sharp KH-6I19BS00-EU Bedienungsanleitung

least 65cm above the hob.
· Extractor fans must be fitted in
accordance with the manufacturer's
instructions.
· The wall in contact with the rear of
the hob must be made of flameproof
material.
· The power cable length should not
exceed 2 metres.
Fitting the hob into a work
surface
· The hob can be inserted into any
worktop provided it is heat resistant up
to at least 90ºC.
· Create an opening with the
dimensions shown in the picture below
and on the next page.
· The induction hob may be built in 25
to 40 mm thick worktops.
· Apply one-sided self-adhesive sea-
ling tape supplied all the way round
the lower glass edge of the cooking
surface along the outer edge of the
glass ceramic panel. Do not stretch it.
· Screw the 4 worktop mounting brac-
kets on the side walls of the product.
EN - 15