Introduction; Intended Use; Residual Risk; Delivery Contents - Parkside PFDS 120 A2 Originalbetriebsanleitung

FLUX CORED WIRE WELDER
PFDS 120 A2
z Introduction
Congratulations!
You have purchased one of
our high-quality devices.
Familiarize yourself with the product before
using it for the first time. Please read the
following operating instructions and safety
instructions carefully. Only trained persons
may set up this tool.
KEEP OUT OF THE REACH OF CHIL-
DREN!
z Intended use
The device is suitable for self-shielded
flux-core welding using an appropriate wire.
No additional gas is required. The protective
gas is contained in powder form in the wire
itself. Thus, it is fed directly into the arc. This
means the device is not susceptible to wind
and can be used outside. Only suitable wire
electrodes may be used for the device. Inten-
ded use also involves compliance with the
safety instructions and assembly instructions
and the operating notes in the operating
instructions.
The applicable accident prevention provi-
sions must be strictly observed. The device
must not be used:
– in rooms with insufficient ventilation,
– in explosive atmospheres,
– for the purpose of thawing pipes,
– in the vicinity of people with cardiac
pacemakers and
– in the vicinity of easily inflammable mate-
rials. Use the product only as described and
only for the specific applications as stated.
Keep these instructions in a safe place. En-
sure you hand over all documentation when
passing the product on to anyone else. Any
use that differs to the intended use as stated
above is prohibited and potentially dange-
rous. Damage caused by disregarding these
instructions or by misuse is not covered by
the warranty or any liability on the part of
the manufacturer.

Residual risk

Even if you operate the device as intended,
there will be residual risks. The following ris-
ks can occur in the context of the design and
construction of this flux-core welding device:
– eye injuries caused by glare
– touching hot parts of the device or the
workpiece (burn injuries),
– in the case of insufficient protection, risk of
accidents and burns due to flying sparks
or slag,
– harmful emissions of smoke and gases cau-
sed by lack of air or insufficient extraction
in closed rooms.
Reduce the residual risk by carefully using
the device as intended and observing all
instruction.
z Delivery contents
1 flux cored wire welder PFDS 120 A2
1 torch nozzle (pre-assembled)
4 welding nozzles (1x 0.9 mm pre-assem-
bled;
1x 0.8 mm; 1x 0.6 mm; 1x 1.0 mm)
1 chipping hammer with wire brush
1 flux-core wire Ø 0.9 mm / 450 g
1 welding mask
1 carrying strap
1 set of operating instructions
z Parts description
1 Cover wire feed unit
2 Carrying strap
3 Mains plug
4
Earth cable with earth terminal
5
Main switch ON/OFF

Introduction

GB / IE / NI 7