Operation; Speed Gearbox; Switching The Appliance On/Off; Setting The Speed - Parkside PDRW 1800 A1 Originalbetriebsanleitung

Operation

2­speed gearbox
CAUTION!
► Operate the speed selector switch 2 only
when the appliance is at a standstill . Other­
wise, the appliance could be damaged .
♦ Set the speed selector switch 2 to position "1"
for a lower speed range .
♦ Set the speed selector switch 2 to position "2"
for a higher speed range .

Switching the appliance on/off

Turn on
♦ Push in the safety button 8 and keep it
pushed in .
♦ Press the ON/OFF switch 9 and keep it
pressed in . You can now release the safety
button 8 .
Switching off
♦ Release the ON/OFF switch 9 .

Setting the speed

♦ Press the + button 6 to increase the speed .
♦ Press the – button 7 to reduce the speed .

Working with the stirrer

♦ Dip the two stirrers 4 into the material you
want to mix at a low speed .
♦ Once both stirrers 4 are completely immersed
in the material, you can increase the speed .
♦ During mixing, move the stirrers 4 through the
mixing container and keep stirring until the
material is thoroughly mixed .
PDRW 1800 A1

Maintenance and cleaning

WARNING! RISK OF INJURY!
Always remove the plug from the
power socket before working on
the power tool.
■ Use a soft, dry cloth to clean the housing .
Never use petrol, solvents or cleaning agents
that can damage plastic .
■ Keep the appliance clean, dry and free from oil
or grease . Do not allow liquids to get into the
paint and mortar mixer .
■ Clean the paint and mortar mixer regularly;
preferably directly after finishing work .
NOTE
► Replacement parts not listed (such as carbon
brushes, switches) can be ordered via our
Service Hotline .
WARNING!
■ If the mains cable requires replacement, this
should be carried out by the manufacturer or
an approved representative to avoid safety
hazards .
GB │ MT │ 37 ■