Philips WardrobeCare GC9940 Bedienungsanleitung Seite 16

EnGlIsh
16
3 Open the lid of the steamer storage compartment (1) and take out
the new anti-calc cartridge (2).
Note: The steamer compartment is designed to store one new anti-calc
cartridge.
Note: To maximise the lifetime of the anti-calc cartridge, leave it packed until
you use it.
4 Remove the packaging and place the new anti-calc cartridge in the
water tank.
Note: To purchase more anti-calc cartridges, go to the Philips online shop at
www.philips.com/shop, or visit Philips online support and search for
GC019.
Automatic Calc Clean
Note: The Auto Calc Clean process is automatically activated the first time you
use the iron after you replaced the anti-calc cartridge.
The appliance cannot be used during the Auto Calc Clean process.
Do not interrupt the Auto Calc Clean process, otherwise the process
restarts.
1 When the Auto Calc Clean process is in progress, the blue AUTO
CALC CLEAN light flashes and the appliance beeps.
This process lasts approximately 3 minutes.
,
During this process it is normal for the system to produce pumping
,
and clicking sounds.
2 After approximately 3 minutes, rinsing water flows into the rinse tray
below. The beeping becomes faster and the red light on the rinse tray
flashes.
3 Pull out the rinse tray.