Before Start; Various Settings; Advanced Setup - Pioneer XDP-30R Bedienungsanleitung

> Before Start > Part Names

Various settings

Advanced Setup

1
Library
Online
Line
Balanced
Out
> Initial Setup
2
Settings
Wi-Fi
Bluetooth
Brightness
Balanced Output Select
Line Out Mode
> Playback
Tap to make settings for Wi-Fi and BLUETOOTH, settings for audio output, pass code
settings, software updates, and a variety of other settings.
1. Tap " " in the home screen.
2. Tap the item you want to set.
∫ Wi-Fi
"On": Connection to a network via Wi-Fi is enabled. This also enables you to make various
settings related to Wi-Fi, such as selecting the SSID of the access point to be connected.
"Off (default value)": Connection by Wi-Fi is not enabled
∫ Bluetooth
"On": Enables connection with a BLUETOOTH wireless technology enabled device. This
also enables you to make various settings related to BLUETOOTH, such as pairing.
"Off (default value)": When BLUETOOTH is not to be used
∫ Brightness
You can adjust the brightness of the screen. The brightness can be set with the slide bar in
10 steps between " (1)" and "
the right (default value is "9").
∫ Balanced Output Select
Use when balanced headphones are to be connected.
"Balanced (default value)": Compared to the normal single-ended operation, you can get a
larger output and the high voltage is not grounded together with the small signal, so you can
anticipate a superior effect in the quality of the music. Because you get a larger output, you
can drive headphones with a higher impedance.
"ACG": The basic operating method is the same as Balanced (mode), but uses technology
to even more forcefully fix grounding standards, so you can enjoy a sound quality with
improved clarity and stability than Balanced (mode). Output volume is the same as the
regular single-ended operation, however.
0 This unit does not support simultaneous use of the balanced headphone jack and the
headphone jack. Using both jacks at the same time may result in damage.
∫ Line Out Mode
"On": Switch the headphone output to the line output mode to connect external equipment.
When "Line Out Mode" is on, output through the headphone jack is at maximum volume, so
do not use headphones. Adjust the volume on the connected device.
0 When turned on for European models, you can then select either "Fixed (default value)"
Advanced Setup | Supplementary Information | Others
(10)". The screen becomes brighter when you slide it to
En 21