Programmable Outputs; Control Functions - Honeywell IDENT-KEY 3 Montage, Anschluss, Anleitung

34
4.6

Programmable Outputs

The functioning of the following outputs can be made subject to specific criteria.
Up to 16 random links
Outputs:
Control function relay
Door strike relay
Semi-conductor output IK2 alarm
Semi-conductor output IK2 disarmed
Semi-conductor output IK2 buzzer
Permanent release
1)
When used with a BPS system, the CF relay is allocated (fixed) as a door strike relay for indoors.
2)
12 V DC / 50 mA, current-limited, short-circuit resistant
Only free in IK3 mode. The output
open detection when the buzzer is programmed accordingly.
Examples for possible programming:
1.) The control function relay must be actuated in the event of a hold-up alarm.
Control function relay
2.) An error message of the armature contact must be indicated as tamper via the semi-conductor
output IK2 disarmed
Semi-conductor output IK2
disarmed
4.7

Control functions

Up to 16 control functions and 1 quick function can be called via the reader keypad.
Control function features:
- Output control (affects the programmable outputs, control function criterion)
- Clear hold-up
- Cancel blocking time
- Time-limted key authorization
Mounting and Connection Instructions IK3 Evaluation Unit Conventional
are possible between outputs, criteria and functions:
Criteria:
1)
Analogue input 1, 2 and 3
Time zones
2)
data carrier
2)
Hold-up
2)
Blocking time
Tamper
Blocking element fault
Control function
Alarm door opening time
IK2-S is used for the door monitoring time and door break-
Hold-up
Tamper
Typ: LC/AC tamper
Functions:
Output follows input
Inverted
On with rising edge
Off with rising edge
Toggle
With/without time limitation
(applies to all functions)
Output follows input
Output follows input