Original Accessories/Additional Equipment; Before Use; Check That The Blade Guard Is Functioning Correctly; Initial Operation - Parkside PHKS 1350 C2 Originalbetriebsanleitung

Changing the batteries
■ Open the cover of the battery compartment
with a suitable Philips screwdriver.
■ Remove the spent batteries.
■ Insert two new 1.5 V alkaline button cells (type
AG 13/LR 44, e.g. GPA 76) observing the
correct polarity and screw the battery compart-
ment cover firmly closed.
CAUTION!
► If operating and adjustment equipment is
used or procedures other than those specified
here are carried out, this may result in
hazardous radiation exposure.
Original accessories/additional
equipment
■ Only use the accessories and additional
equipment that are specified in the operating
instructions and are compatible with the
appliance.

Before use

Check that the blade guard is
functioning correctly
WARNING! RISK OF INJURY!
■ Switch off the appliance and pull out the
power plug before starting any work on
the appliance.
■ Make sure that all moving parts of the blade
guard move freely without jamming and all
devices designed to cover the saw blade are
working correctly.
■ Activate the blade guard
release lever for the blade guard
♦ Pull the release lever for the blade guard
all the way back.
When you let go of the release lever for the
blade guard , the blade guard
move freely back to its starting position.
PHKS 1350 C2
only using the
.
must

Initial operation

The PHKS 1350 C2 circular saw has Intelligent
Power Control. This automatic power delivery
system ensures that for a particular speed range
the power output remains constant when working
on harder and more resistant materials.

Fitting/changing the saw blade

NOTE
► All blades used should conform to EN 847-1.
■ Use only saw blade with diameters
corresponding to the label on the saw.
Always pull out the plug from the mains before
changing the saw blade
1. Set the cutting depth (using the locking
screw ) to the minimum position, 0 mm.
2. Swing the blade guard
release lever and put the device down.
3. Press the spindle lock button
and use the Allen key
clamping screw/washer
clamping screw/washer
flange (see also Fig. A).
Fig. A: Changing the saw blade
4. Remove saw blade
5. Fitting a saw blade
reverse order.
6. Press the spindle lock button
engages) and use the Allen key
the clamping screw/washer
!
back using the
(until it engages)
to release the
. Now remover the
and the clamping
.
is carried out in the
(until it
to tighten
.
GB │ MT │
51 ■