Replacing The Air Filter; Spark Plug Maintenance; Changing The Engine Oil - Parkside PBM 125 A1 Originalbetriebsanleitung

• Check the device before each use for
obvious defects such as loose, worn or
damaged parts. Ensure that all nuts,
bolts and screws are firmly in place.
• Check the covers and protective de-
2, 8, 16, 20) for damage
vices (
and correct fit. Replace these if neces-
sary.
Replacing the air filter
Never run the device without an air
filter. Dust and dirt may otherwise
enter the engine and cause dama-
ge.
Removing the air filter
1. Disconnect the spark plug connector
12) (see "Spark plug maintenance").
(
2. Open the air filter box (10).
3. Remove the air filter (11).
4. Clean the air filter (11) in a soap soluti-
on.
5. Allow the air filter (11) to dry. Put a
few drops of fresh engine oil into the
air filter.
6. Replace the faulty air filter with a new
air filter (see „Spare parts/Accesso-
ries").
Inserting the air filter
1. Insert the air filter (11) into the air filter
box (10).
2. Close the air filter box (10) back up.

Spark plug maintenance

Worn spark plugs, or a spark plug
gap that is too large, will lead to a
reduction in engine power.
1. Remove the spark plug connector (12)
by pulling and turning the spark plug
(13).
2. Unscrew the spark plug (13) coun-
ter-clockwise with the enclosed
spark plug wrench (
3. Check the spark plug gap with the help
of a feeler gauge (available from spe-
cialised dealers). The spark plug gap
must be 0.7-0.8 mm.
4. Reset the gap if necessary, by carefully
bending the ground/side electrode of
the spark plug.
5. Clean the spark plug with a wire brush.
6. Insert the cleaned and set spark plug or
replace a damaged spark plug with a
spare spark plug (
ded tightening torque 20 Nm, deter-
mined with torque wrench) (see "Spare
parts/accessories").

Changing the engine oil

Change the engine oil when the
petrol tank is empty and the engine
is warm.
• Perform the first engine oil chan-
ge after about 5 operating hours
and then every 50 operating
hours or annually.
• Dispose of the used oil in an
environmentally-responsible way
(see „Disposal/Environmental
Protection").
1. Disconnect the spark plug connector
12) (see "Spark plug maintenan-
(
ce").
2. Open the oil tank cap (
3. Pump out the engine oil with an oil
pump (not included in delivery).
3. Top up the engine oil (see "Filling the
engine oil").
IE NI
27).
26) (recommen-
19).
17