No Signal Off; No Operation Off - Pioneer PDP-4280XA Bedienungsanleitung

08 Setting up
Energy Save
Selections Off
Mode 1
Mode 2
Picture Off
5 Press HOME MENU to exit the menu.
Note
• When you change the Energy Save mode, you may notice a
change in the panel sound. This is normal.
• The Energy Save function can maintain efficiency of the screen
for a long period of time. Setting the Energy Save function to
"Mode 1" is recommended in order to maintain the efficiency of
the screen for a long period of time.
No Signal off (AV source only)
The system will be automatically placed into the standby mode if no
signal is received for 15 minutes.
1 Press HOME MENU.
2 Select "Power Control" (/ then ENTER).
3 Select "No Signal off" (/ then ENTER).
4 Select "Enable" (/ then ENTER).

No Signal Off

Selections Disable
(default)
Enable
5 Press HOME MENU to exit the menu.
Note
• Five minutes before the system is placed into the standby mode,
a message appears every minute.
• The system may not be placed into the standby mode when
noise signals are present at the plasma television after a TV
programme finishes.
34
En
Does not decrease the picture
brightness
Slightly lowers power consumption
while slightly suppressing the
brightness drop level
Decreases the picture brightness
and lowers power consumption
Deactivates the screen to save
power. To restore the screen
display, press any button other
than i +/i – and e.
This setting is not memorized by
the system.
Does not place the system into the
standby mode
Places the system into the standby
mode if no signal is received for 15
minutes
No Operation off (AV source only)
The system will be automatically placed into the standby mode
when no operation is performed for three hours.
1 Press HOME MENU.
2 Select "Power Control" (/ then ENTER).
3 Select "No Operation off" (/ then ENTER).
4 Select "Enable" (/ then ENTER).

No Operation off

Selections Disable
(default)
Enable
5 Press HOME MENU to exit the menu.
Note
• Five minutes before the system is placed into the standby mode,
a message appears every minute.
Power Management (PC source only)
The system will be automatically placed into the standby mode
when no signal is received from the personal computer.
1 Press HOME MENU.
2 Select "Power Control" (/ then ENTER).
3 Select "Power Management" (/ then ENTER).
4 Select "Mode 1" or "Mode 2" (/ then ENTER).
Item Description
Off (default) No power management
Mode 1 · Places the system into the standby mode when
no signal is received from the personal computer
for eight minutes.
· Even when you start using the computer and a
signal is received again, the system stays off.
· The system is switched on again by pressing
STANDBY/ON on the plasma television or a on
the remote control unit.
Mode 2
· Places the system into the standby mode when
no signal is received from the personal computer
for eight seconds.
· When you start using the computer and a signal
is input again, the system is switched on.
· The system is switched on again by pressing
STANDBY/ON on the plasma television or a on
the remote control unit.
5 Press HOME MENU to exit the menu.
Note
• This function is not selectable when the PC is connected to the
HDMI terminal.
Does not place the system into the
standby mode
Places the system into the standby
mode if no operation is performed
for three hours