Switching The Broadcast Audio Channel; Freezing Images - Pioneer PDP-4280XA Bedienungsanleitung

06 Watching TV
Using e on the remote control unit
1 Press e to mute the sound.
e appears on the screen.
Muting
Press e again or i + to restore the sound.
2

Switching the broadcast audio channel

Depending on the broadcast, you can switch the audio channel.
Press - to change the audio channel.
•
mode
I
The table below shows the available audio channels by broadcast
audio type.
1
AAA
Stereo
NICAM STEREO
10:00
2
BBB
Bilingual
NICAM I
10:00
3
CCC
Monaural
NICAM MONO
10:00
4
DDD
Stereo
STEREO
10:00
5
EEE
Bilingual
DUAL I
10:00
6
FFF
Monaural
MONO
10:00
22
En
mode MONO mode
II MONO
Setting
MONO
1
AAA AAA
NICAM STEREO MONO
10:00 10:00
2
BBB BBB
NICAM II MONO
10:00 10:00
3
CCC
NICAM MONO MONO
10:00 10:00
4
DDD DDD
STEREO MONO
10:00 10:00
5
EEE EEE
DUAL II MONO
10:00 10:00
6
FFF
MONO MONO
10:00 10:00
Note
• In each of the sound multiplex mode selected using the -
button, the display changes depending on broadcasting signals
being received.
• Once the MONO mode is selected, the sound remains mono
even if the system receives a stereo broadcast. You must switch
the mode back to  or  mode if you want to hear stereo sound
again.
• Selecting a sound multiplex mode while the input source is
"INPUT 1" to "INPUT 5" does not change the type of sound. In
this case, sound is determined by the video source.

Freezing images

Use the following procedure to capture and freeze one frame from
a moving image that you are watching.
Important
• Displaying a static image for a long period of time, or for shorter
periods of time everyday, may result in image retention.
1 Press d.
A still image appears on the right screen while a moving image is
shown on the left screen.
1
2
3
CCC
4
Normal image
Press d again to cancel the function.
2
5
Note
6
• When this function is not available, a warning message
FFF
appears.
Still image