Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
TROUBLESHOOTING GUIDE
Oven not working:
•
Check for the presence of mains electrical power and if the oven is connected to the electrical supply.
•
Turn off the oven and restart it to see if the fault persists.
The electronic programmer does not work:
•
If the display shows the letter " " followed by a number, contact your nearest After-sales Service. Specify in this case the
number after the letter " ".
AFTER-SALES SERVICE
Before calling the After-Sales Service:
1.
See if you can solve the problem yourself with the help of the suggestions given in the "Troubleshooting guide".
2.
Switch the appliance off and then on again it to see if the problem has been eliminated.
If the fault persists after the above checks, contact the nearest After-sales Service.
Always specify:
•
a brief description of the fault;
•
the type and exact model of the oven;
•
the service number (number after the word Service on the rating plate), located on the right hand edge of the oven cavity
(visible when the oven door is open). The service number is also indicated on the guarantee booklet;
•
your full address;
•
your telephone number.
If any repairs are required, contact an authorised After-sales Technical Service (to guarantee the use of original spare parts
and correct repair).
CLEANING
WARNING
Oven exterior
IMPORTANT: Do not use corrosive or abrasive detergents. If any of these products accidentally comes into contact with
the appliance, clean it immediately with a damp cloth.
•
Clean the surfaces with a damp cloth. If very dirty, add a few drops of neutral detergent to the water. Dry with a dry cloth.
Oven interior: PURECLEAN™ cleaning cycle
IMPORTANT: Do not use corrosive or abrasive detergents. Do not use abrasive sponges, metal scrapers or scouring pads
different from the sponge provided. Their use could eventually ruin the enamelled surfaces. Only use non-abrasive
sponges to clean the door glass.
The cavity of this oven is coated with a special formula enamel (nickel-free) enabling easily cleaning using just water and the
cellulose cloth provided. The cellulose cloth is washable and reusable until worn, and can be purchased from the Customer Care
Service. Washing the cloth in a washing-machine and drying it in a dryer is inadvisable.
PURECLEAN™ cleaning cycle
To keep the oven in best condition, carry out the PURECLEAN™ cleaning cycle after each use. The cycle takes 35 minutes,
including a cooling stage, and must be carried out as follows:
1.
Proceed with oven cold.
2.
Wet the cellulose cloth provided under running water and wring it out so that it does not drip.
3.
Open the oven door and remove the enamelled accessories.
4.
Cover the bottom of the oven completely with the cellulose cloth.
5.
Distribute 350 ml of water evenly on the cellulose cloth. A smaller or greater amount of water could compromise proper
functioning of the cycle.
6.
Close the oven door.
7.
Select the symbol
8.
Press button
during the cycle.
9.
At the end of the cycle, remove the cellulose cloth and eliminate any residual water in the oven.
10. Then start cleaning using the sponge provided, moistened with hot water (cleaning could be compromised if delayed by
more than 15 minutes).
Downloaded from
www.Manualslib.com
-
Never use steam cleaners.
-
Clean the appliance when it is cold.
-
Disconnect the appliance from the power supply.
with the functions knob: the word PURECLEAN™ appears on the display.
to confirm the choice and start the cleaning cycle. To prevent steam coming out, do not open the door
manuals search engine
GB22
Werbung
Inhaltsverzeichnis
