Herunterladen Inhalt Inhalt Diese Seite drucken

Cannot Connect To A Server; Problems With Network - Acer Altos G520-Serie Benutzerhandbuch

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

128

Cannot Connect to a Server

Make sure the network cable is securely attached to the correct
connector at the system back panel.
Try a different network cable.
Make sure you are using the correct and the current drivers.
Make sure the driver is loaded and the protocols are bound.
Make sure the hub port is configured for the same duplex mode as
the network controller.
Make sure the correct networking software is installed.
If you are directly connecting two servers (without a hub), you will
need a crossover cable.
Check the network controller LEDs next to the NIC connectors.

Problems with Network

The server hangs when the drivers are loaded.
Certain drivers may require interrupts that are not shared with
other PCI drivers. For these drivers, it may be necessary to alter
settings so that interrupts are not shared. See the documentation
that came with your PCI card(s) for information on changing
interrupts.
Diagnostics pass but the connection fails.
Make sure the network cable is securely attached.
Make sure you specify the correct frame type in your NET.CFG file.
The controller stopped working when an add-in adapter was
installed.
Make sure the cable is connected to the port from the onboard
network controller.
Make sure your BIOS is current.
Make sure the other adapter supports shared interrupts. Make
sure your operating system supports shared interrupts.
Try reseating the add-in adapter.
Appendix A: Troubleshooting

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis