Operation; Technical Data - HANSGROHE Metropol 14840000 Montageanleitung

Important! The fitting must be installed,
flushed and tested after the valid norms.
Assembly
1. Flush through the supply pipes.
2. Mount the S - unions and align them.
3. Fasten the mixer with the washers.
The hot and cold supplies must be of equal
pressures.

Operation

The mixer is activated by pulling the lever handle.
Turning to the left = warmer water,
turning to the right = cooler water.

Technical Data

Operating pressure:
Recommended operating pressure:
Test pressure:
Hot water temperature:
Recommended hot water temperature: 65° C
Centre distance:
Connections G 1⁄2":
Rate of flow by 3 bars:
Hansgrohe single lever mixers can be used toge-
ther with hydraulically and thermically controlled
continuous flow heaters if the flow pressure is at
least 1.5 bars.
To adjust the hot water limiter on single lever
mixers, please see page 11.
No adjustment is necessary when using a conti-
nuous flow water heater.
6
English
Spare parts (see page 3)
1
1.1 screw cover
2
3
4
5
6
7
8
9
max. 10 bars
1 - 5 bars
16 bars
max. 80° C
150 ± 16 mm
cold right
hot left
approx. 22l/min
handle
flange
nut
cartridge cpl.
spout cpl.
aerator cpl.
ball S - unions
flange
noise reduction
14890000
96338000
94192000
94194000
92730000
92835000
13913000
94140000
94135000
96429000