Herunterladen Inhalt Inhalt Diese Seite drucken

Installation Procedure - Pioneer KURO KRP-WM01 Bedienungsanleitung

Wandbefestigungseinheit
Inhaltsverzeichnis

Werbung

Installation Procedure

* The Pioneer display and television illustration shows the
KRP-600M.
1
Attach the display side fittings to the
Pioneer display and television.
Securely attach the display side fittings to the Pioneer
display and television with the M8 Allen bolts (four
locations), being careful to correctly orient the display
side fittings the right side up as shown in the illustration.
• Place the Pioneer display and television down on a
sheet or similar material to protect it from scratches
and damage.
• Always place the Pioneer display and television on a
stable surface such as a table.
Fall prevention
screw
Cables
• If you plan to install speakers, do so at this stage.
For the installation procedure, refer to the operating
instructions.
• Connect the various cables to the Pioneer display and
television at this stage. Do not yet connect the various
cables to their respective peripherals.
• Be careful not to pinch the cables in the display side
fittings.
• In this state, attach the wire to the display side
fittings. Use a commercially available safety wire,
spring hook, and eye plate (or eye bolt) of sufficient
strength to support the weight of the Pioneer display
and television.
Spring hook
Pass a safety wire through the
holes of the display side fittings.
Place is so the
top is here.
Be sure to pass the speaker
cables, etc., between the
Pioneer display and television
and fall-prevention screw.
Eye plate
Eye bolt
• Attach the eye plate (or eye bolt) on the side of
the wall where the fall-prevention measure is
implemented at a location of sufficient strength to
resist the weight of the Pioneer display and television.
• Be careful to terminate the wires so that they will
not get inside the ventilation openings of the Pioneer
display and television.
2
Attach the Wall side fittings to the wall.
Attach the wall side fittings to the wall in a horizontally
symmetrical pattern (eight or more locations). Be sure
to use screws and bolts suited for the strength and
material of the wall.
Make sure that the installation location is sufficiently
strong to withstand the weight of the Pioneer display and
television.
: Attachment holes (attach wall side mount at horizontally
symmetrical locations, eight or more locations)
* If using eight or more locations, use other attachment
holes.
KRP-WM01
KRP-WM02
1 First select the Pioneer display and television attachment
location by checking the strength of the wall or beam,
and then determine the location that corresponds to the
screen center.
Screen center
11
En

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Kuro krp-wm02Krp-wm01Krp-wm02Kuro krp-wmo1Kuro krp-wmo2

Inhaltsverzeichnis