Settings; Configuring The Hdmi Control Function; Configuring Hdmi Audio Output - Yamaha ATS-CU2070 Bedienungsanleitung

Settings

Configuring the HDMI control function

Follow the procedure below to enable or disable the unit's HDMI
control function. This function is enabled by default.
1
Turn off the unit.
2
Hold down the HDMI key on the unit's remote control
for more than 3 seconds.
The HDMI control function is enabled or disabled, and the unit
turns on. The indicator shows HDMI control function status for
several seconds immediately after the unit is turned on.
NOTE
• Enable the HDMI control function when connecting a TV that supports Audio Return
Channel (ARC) (p. 21), or when using HDMI signal pass-through (p. 21).
If the unit cannot be operated with the TV's remote control
Confirm the settings are properly configured as described below.
- The HDMI control function of this unit is enabled.
- The HDMI control function is enabled on the TV.
Examples of TV settings
• From the setup menu on your TV, select "Link setting" ➔ "HDMI control
setting", then set a setting such as "HDMI control function" to "ON".
• Set audio output to any option other than TV.
If the unit cannot be operated with the TV's remote control even after the settings
described above have been applied correctly:
- Turn off this unit and the TV, and then turn them back on again.
- Disconnect the power cables of the center unit, subwoofer, and external devices
connected to the center unit via HDMI cable. Plug them in again after about 30
seconds.
32
En
Glows (enabled; default)
Off (disabled)

Configuring HDMI audio output

Specify whether HDMI audio input signal will be played from the unit
or the TV. This setting can only be configured when the HDMI control
function is disabled.
The unit (default) Play HDMI audio input signal from the unit.
TV Play HDMI audio input signal from the TV
connected to the HDMI OUT (ARC) jack on
the unit. The unit cannot be used to adjust
volume. Use TV controls to adjust volume.
1
Turn off the unit.
2
Hold down the SURROUND key on the remote control
for more than 3 seconds.
HDMI audio output switches between this unit and the TV, or
vice versa, and the unit turns on. The indicator shows HDMI
audio output status for several seconds immediately after the
unit is turned on.
Glows (audio is played from the unit; default)
Off (audio is played from the TV)
NOTE
• To configure HDMI audio output with the HDMI control function enabled, select the
audio output device configured for the TV connected to this unit.
• HDMI video signals input to the HDMI IN jack of this unit are always output from the
HDMI OUT (ARC) jack of this unit.