Kenwood SS496 Bedienungsanleitung Seite 5

know your Kenwood
steam station
funnel
iron rest mat
cord support
steam supply cord
tank release lever
water tank cover
water tank
power supply cord
iron switch
tank switch
ready to steam indicator light
variable steam control (models
SS498 and SS499 only)
water tank empty indicator light
iron rest (fixed)
boiler cap
temperature indicator light
temperature control
soleplate
steam button
lock for continuous steam
k PTFE soleplate, not shown (model
21
SS499 only)
using your steam station
1 Place the steam station on the
support of the ironing board or any
other stable surface nearby with the
iron sitting on the iron rest. Make
sure that all the buttons are off, the
steam station is unplugged and that
the power and steam supply cords
are unrolled and not kinked.
2 Fit the cord support into the tank
and place the steam supply cord
into the hook on the other end. This
will keep the cord in an upright
position.
filling with water
1 Remove the water tank by sliding
the lever towards the outside
simultaneously lifting up the tank
2 Remove the tank cover by turning
anti-clockwise and lifting off.
3 Fill the tank under the tap.
4 Refit the cover and replace the tank
into its original position by gently
pushing into place.
G
Filtered water is best as it reduces
limescale, prolonging the life of your
steam station (Kenwood water filters
are widely available). Alternatively
use tap water.
G
If you need to refill your steam
station during use, we recommend
the water tank is removed for filling.
If filled whilst fitted, always unplug
the steam station first.
choosing the right
temperature
Follow the clothes label advice.
Match the dots on the label to the
dots on the temperature control. If
there's no label, here's a guide on
which temperature to choose:
hints
G
Start on clothes needing the lowest
temperature, then work upwards.
(This lowers the risk of burning
something because an iron switched
from 'hot' to 'cool' takes time to
cool down.)
G
For mixed fibres, eg cotton
polyester
temperature
G
If in doubt, start with a low
temperature on a part that won't be
seen (eg a shirt tail).
and
.
3
G , use the lowest suitable
G .
GGG and