Connecting To A Compressed Air Source - Parkside PDRS 6.3 B2 Originalbetriebsanleitung

Connecting to a compressed air source

NOTE
► Before connecting the compressed air source,
–
the correct working pressure (6 .3 bar) must be fully
reached, and
–
make sure that the trigger is in the upper position .
► Use only connection hoses with an internal diameter of at least
9 mm .
► Use only filtered, lubricated and regulated compressed air .
♦ Attach the tool to a compressor by connecting the connector
nipple with the supply hose of the compressed air source .
CAUTION!
► Ensure that the compressed air hose is firmly attached . A loose
hose can thrash about uncontrollably causing grave danger .
Likewise, ensure the firm seat of the two screw connections
between the coupling piece and the appliance .
♦ The compressed air source must be equipped with a pressure
reducer so that you can regulate the air pressure .
PDRS 6.3 B2 GB │ CY │ 23 ■