Hazards Caused By Flying Parts - Parkside PDRS 6.3 B2 Originalbetriebsanleitung

■ The machines must be serviced regularly to check whether the
rated values and markings required in the present part of ISO
11148 are appended legibly on the machine . The employee/
operator must contact the manufacturer to obtain replacement
stickers for labelling if this is necessary .

Hazards caused by flying parts

■ If a workpiece or one of the accessory parts or even the machine
tool itself breaks, parts can be thrown off at high speeds .
■ Always wear impact-resistant safety goggles during operation,
when replacing accessory parts or during repair or maintenance
work .
The level of the required protection must be evaluated separately
for each individual task .
■ You must ensure that the workpiece has been securely fixed in
place .
■ Check regularly that the rotation speed of the compressed air tool
is not higher than the specified rotation speed appended on the
compressed air tool . These rotation speed tests must be conduct-
ed without any accessory tools attached .
■ Ensure that sparks and fragments created during work do not
present any hazards .
■ Separate the compressed air tool from the compressed air supply
before replacing the attachment or accessories or before you
adjust the settings, service or clean the tool .
■ Ensure that no dangers are created for other persons either .
PDRS 6.3 B2 GB │ CY │ 13 ■