Advice On Use - Parkside PWS 230 SE Bedienungs- Und Sicherheitshinweise

pipe can lead to an explosion. Penetration of a
water pipe can lead to property damage or to
electric shock.
J
WArNING!
Working with harmful / noxious dusts represents
a risk to the health of the person operating the
device and to anyone near the work area.
J
For longer periods of cutting or grind-
ing metal or stone materials which
give rise to dusts that are hazardous
to health, the device must be connected
to a suitable external dust extraction
device.
J
Ensure that there is adequate ventila-
tion when working on plastic, paint,
varnish etc.
J
Do not soak the materials or the sur-
face you are about to work on with
liquids containing solvents.
J
DANGEr OF INJUry! Wear close-fitting
clothing and keep long hair inside a
hairnet or suitable headwear.
J
For safety reasons this device must
always be used with the auxiliary
handle
J
the adjustable disc guard cover
must always be in place when work-
ing with roughing, grinding or cutting
discs. otherwise there could be danger of in-
jury.
J
Use the vacuum dust extraction facility
if your work generates high amounts
of dust. Use suction devices particular-
ly approved for the purpose.
J
Use permitted consumables and tools
only. Check that the speed given on the
discs is greater or equal to the rated
speed of the device.
J
take note of the direction of rotation
and always hold the device in such a
way that the sparks and grinding de-
bris are thrown away from your body.
otherwise there could be danger of injury.
J
Make sure that the dimensions of the
disc are suitable for the device and
that the disc is of a type that fits prop-
erly on to the mounting flange
Downloaded from www.Manualslib.com
NOxIOUS FUMES!
in place.
6
manuals search engine
General safety advice for electrical power tools

Advice on use

Q
Note! Discs must be used only for their recom-
mended purposes, otherwise they could disintegrate,
become damaged or cause accidents.
roughing:
Never use cutting discs for
roughing or grinding!
J
Move the angle grinder using even
pressure to and fro over the workpiece.
J
Hold the roughing or grinding disc at
a flat angle to the workpiece when
working on a soft material. Use a
slightly steeper angle for harder ma-
terials.
Disc-cutting:
Never use roughing or
grinding discs for cutting!
J
Only use certified fibre-reinforced cut-
ting or grinding discs approved for use at
circumferential speeds of not less than 80 m / s.
CAUtION! The disc continues to rotate after
7
the device has been switched off. Do not at-
tempt to slow it down by pressing on the side
of the disc.
J
Securely support the workpiece. Use
clamps or a vice to grip the workpiece firmly.
This is much safer than holding it in your hand.
J
Switch the device off and allow it to
come to a complete standstill before
you put it down.
J
Unlock the ON / OFF switch immedi-
ately if a power failure occurs or the
plug is pulled out of the mains socket.
Place the switch in the OFF position.
This prevents the device from being inadvertent-
ly started up again.
J
Use the device for dry cutting or dry
grinding only.
J
the auxiliary handle
whenever the device is being used.
J
Do not work on materials containing
. asbestos. Asbestos is a known carcinogen.
15
must be in place
6
GB/MT 43