First Use; Switching On And Off; Infinitely Adjustable Speed Setting; Setting The Direction Of Rotation - Parkside PSBM 500 A1 Bedienungs- Und Sicherheitshinweise

©

First use

© Switching on and off
When operating the hammer-action drill you can
select between intermittent or continuous operation
mode. In either mode the device functions as follows:
To switch on intermittent operation mode:
Press the ON / OFF switch
To switch off intermittent operation mode:
Release the ON / OFF switch
Switching continuous operation on:
Press and hold the ON / OFF switch
and press the locking button
To switch off continuous operation mode:
Press and then release the ON / OFF switch
© Infinitely adjustable
speed setting
The ON / OFF switch
Pressing the ON / OFF switch
speed.
©

Setting the direction of rotation

With the rotational direction switch
change the rotational direction of the electrical
tool.
NOTE: This is, however, not possible when the
ON / OFF switch
NOTE: Hold the appliance in the direction of work.
Clockwise rotation:
Push the rotational direction switch
right in order to drill and to screw in screws.
Downloaded from www.Manualslib.com
First use / Servicing and cleaning / Service centre
6 .
.
6
6
5 .
has a variable speed control.
6
6 increases the
7
6 is pressed down.
7
manuals search engine
Anticlockwise rotation:
Push the direction of rotation switch
left to slacken a screw or screw it out.
© Switching between drilling /
hammer-action
Note: The hammer-action drilling mode is intended
for drilling into brick, concrete and stone only.
Note: The drill / hammer-action switch
only be moved after the device has come to a
standstill.
Drilling:
down Set the drill / hammer-action switch
right into the position.
Impact drilling:
. Set the drill / hammer-action switch
6
left into the
©

Servicing and cleaning

WARNING!
Switch the device off and pull the plug out of the
mains socket before carrying out any work on the
device.
Do not allow any liquids to enter the device.
Use a cloth to clean the device.
Clean the device after you have finished using it.
you can Do not under any circumstances use petrol or
strong solvents.
Store the device in a dry room.
©

Service centre

WARNING!
only by qualified specialist personnel
to the
using original manufacturer parts only.
This will ensure that your device remains safe
to use.
WARNING!
needs to be replaced, always have
to the
7
4 must
to the
4
to the
4
position.
DANGER OF INJURY!
Have your device repaired
If the plug or mains lead
GB/CY 11