Problems That Can Be Resolved Before Calling The Customer Service Centre - AEG Electrolux CG 6200 Gebrauchsanweisung

822_949_351 CG6200.book Seite 47 Sonntag, 4. März 2007 11:22 23
• The coffee runs off too slowly.
0 Turn the knob for setting grinding tex-
ture (Fig. 12) one click clockwise whilst
the grinder is grinding beans for the
preparation of next coffee (see „Set-
ting the grinding texture", page 42).
The symbol
• The waste coffee container is full.
0 Empty the waste coffee container and
clean it as described in the section
„Emptying the waste coffee container",
page 44, then replace it.
The symbol
• The waste coffee container has proba-
bly not been replaced after cleaning.
0 Open the service door and insert the
waste coffee container.
The symbols
flashing
• With the ground coffee function
selected, ground coffee has not been
poured into the ground coffee filler.
0 Add the ground coffee as described in
chapter „Using pre-ground coffee",
page 40.
All coffee strength symbols
and
• The coffee beans have run out.
0 Fill the coffee bean container, see „Fill-
ing the coffee bean container",
page 35
• If the coffee grinder is very noisy, this
could mean a small stone in the coffee
beans has blocked the grinder.
0 Contact the Customer Service Centre.
Blocking or damage caused by for-
eign objects in the grinder might be
excluded from the guarantee.
The symbol
• This indicates the presence of limescale
in the appliance.
0 The descaling procedure, described in
the section „Running the descaling
program", page 45, needs to be per-
formed as soon as possible.
0 Close the service door. If the service
is on steady
0 Insert the brewing unit; see „Cleaning
0 Thoroughly clean the inside of the
is flashing
or and are
0 Contact the Customer Service Centre.
0 Turn the steam knob clockwise (Fig. 10)
are flashing
0 Use the appliance in a warmer room.
16
is on steady
The symbol is on steady
• The service door is open.
door cannot be closed, check that the
brewing unit is inserted correctly (see
„Cleaning the brewing unit", page 44).
The symbol is flashing
• The brewing unit has probably not
been replaced after cleaning.
the brewing unit", page 44
• The inside of the appliance is very dirty.
appliance; see „Cleaning the brewing
unit", page 44. If the message is still
displayed after cleaning, contact the
Customer Service Centre.
The symbol is on steady
• This indicates a general alarm.
The symbols and
• The machine has been switched on
with the steam knob in open position
.
as far as it will go, to the position
The symbols and are flashing
• The ambient temperature is too low to
operate the applience.
Problems that can be
resolved before calling the
Customer Service Centre
If the appliance is not working, the
causes of the malfunction can be iden-
tified and resolved by referring to
chapter „What to do if you see the fol-
lowing symbols on the display ...",
page 46. If, on the other hand, no sym-
bol is displayed, run the following
checks before calling the Customer
Service Centre.
g
are flashing
.
47