Setting The Coffee Temperature; Cleaning And Care; 13.1 Regular Cleaning - AEG Electrolux CG 6200 Gebrauchsanweisung

822_949_351 CG6200.book Seite 43 Sonntag, 4. März 2007 11:22 23
12 Setting the coffee
temperature
There are three temperature levels to
choose from. The factory setting is
«Temperature high». You can change
this setting as follows:
0 Press the "P" key (Fig. 4).
The symbols "P" and
thermore 3 small symbols above the
, and
show the present function of these
buttons, see „Special mode", page 35.
0 Press the scrolling keys "<" or ">"
(Fig. 5) until the symbol
nated.
0 Confirm with the "OK" key (Fig. 5).
The display indicates the current set-
ting. The temperature levels are indi-
cated as follows:
Temperature low
Temperature medium
Temperature high
0 Where necessary, select a different
temperature, using the scrolling keys
"<" or ">" (Fig. 5).
0 When the required temperature is indi-
cated, confirm this with the "OK" key
(Fig. 5). This temperature is now pro-
grammed.
To cancel without storing the setting,
3
press "P" instead of "OK".
If "OK" is not pressed, after about
120 sec. the appliance returns auto-
matically to the coffee mode without
storing the setting.
0 To return to the coffee mode, press the
"P" key (Fig. 4) or wait about 120 sec.
for the machine to return automati-
cally to the coffee mode.
13

13.1 Regular cleaning

1
come on. Fur-
buttons come on to
1
is illumi-
1
1
0 Remove the water tank daily (Fig. 6)
0 Empty the waste coffee container daily
0 Regularly drain the drip tray. This can
0 Regularly (at least once per week)
0 Each time the machine is used for
0 Check that the holes in the coffee dis-

Cleaning and Care

To ensure consistent coffee quality and
faultless operation, always keep your
coffee machine clean.
Caution! Before cleaning, switch off
the coffee machine and allow it to cool
down.
Note! Never put the coffee machine or
separate parts of the coffee machine in
the dishwasher. Never immerse the
coffee maker in water.
Note! Never put water in the coffee
bean container, as this would damage
the grinder.
Do not use any abrasive, scouring or
corrosive cleaning materials. Wipe the
inside and outside of the case only
with a damp cloth.
and discard any remaining water. Rinse
out the water tank with fresh water.
Use fresh water every day.
or at the latest when the display
prompts you to do so; see „Emptying
the waste coffee container", page 44.
be done at any time, but must be done
when the red drip tray float (Fig. 28)
appears through the opening in the
drip grid.
clean the water tank (N), drip tray (O),
drip grid (A) and waste coffee con-
tainer (Q) with warm water, a mild
washing up liquid and possibly a brush.
frothing, remove the steam nozzle and
clean off any milk residues, see „Clean-
ing the steam nozzle", page 41.
penser are not blocked. To unblock
them, scrape any dry coffee residues
away with a needle (Fig. 29).
g
43