Frothing Milk - AEG Electrolux CG 6400 Gebrauchsanweisung

g
appliance will not make the coffee, the
ground coffee will be dispersed inside
the appliance, dirtying it, or the coffee
will be delivered drop by drop and the
message «GROUND TOO FINE
ADJUST MILL
AND TURN KNOB» will be dis-
played.
Do not add ground coffee during the
brewing process. Only put in ground
coffee for the next cup when the
brewing process has completely fin-
ished and the coffee machine is ready.
Never add the ground coffee when the
appliance is off, as otherwise it will be
dispersed inside the appliance.
Use only ground coffee for fully auto-
1
mated espresso coffee makers. Do not
put coffee beans, any water-soluble or
freeze-dried instant products or any
other drink powder into the ground
coffee filler. Coffee powder which is
too fine can lead to blockages.
If the filler shaft is blocked (due to
3
moisture inside the appliance, or
because more than 2 measuring scoops
of pre-ground coffee have been used),
use a knife or a spoon handle to push
the coffee down (Fig. 23). Then remove
the brewing unit and clean it and the
appliance as described in the section
„Cleaning the brewing unit", page 51".
0 Close the lid.
If you do not activate any key within
3
few seconds after having selected the
"Pre-ground coffee" function, the
appliance will suggest the next step in
the display: «PRESS 1 OR 2 CUPS
KEY»
0 To choose the required cup size, turn
the knob for "Cup size" (Fig 13). The
selected cup size will be displayed.
0 Press the key for "1 cup"
one cup, or the key for "2 cups"
make 2 coffees.
The coffee is prepared.
44
Once the coffee has been prepared, to
3
go back to making coffee using beans,
turn the "Coffee strength / Pre-ground
coffee" knob (Fig. 21) to any coffee
strength setting (the coffee mill is ena-
bled for operation again).
10

Frothing milk

The steam can be used to froth milk
and to heat liquids. Since a higher
temperature is needed to produce
steam than to make coffee, the coffee
machine has an additional steam
mode.
To make a cappuccino, fill a large cup
3
1/2 to 2/3 full with espresso, and then
add the frothed milk.
1 Caution! Danger of scalding when the
steam nozzle is activated! Hot water or
steam output can cause scalding. Do
not activate the steam nozzle until it is
immersed in the milk.
0 To produce steam, press the "Steam"
key (Fig. 24).
The display shows «HEATING UP...»
in the upper line and in the lower line
an advancing progress bar with a per-
centage indication
«
When the heating process is finished,
the display shows «STEAM». The
machine is ready for the milk frothing.
If you do not perform any further
3
action within a few seconds after the
message «STEAM» is shown on the
display, the appliance will suggest the
next step, showing «STEAM» in the
upper line of the display and «TURN
KNOB FOR STEAM» in the lower
line.
If the steam function is not used for
3
to make
longer than 2 minutes, the machine
to
switches back automatically to the
coffee mode.
40%».