AEG Electrolux CG 6400 Gebrauchsanweisung Seite 41

gram (Programming the fill level)",
page 48.
You can also choose coffee with an
extra-mild, mild, normal, strong or
extra-strong strength.
0 To choose the required strength, turn
the knob for "Coffee strength selec-
tion" (Fig 14). The selected coffee
strength will be displayed.
0 Place one or two cups under the coffee
dispensing spouts (Fig. 15). The dis-
penser can be slid up or down, to
match the height of your cup/mug to
reduce heat loss and coffee splashes
(Fig. 16).
If you do not press any further keys
3
within a few seconds after having
changed the parameters of cup size or
coffee strength, the appliance will sug-
gest the next step: «PRESS 1 OR 2
CUPS KEY».
0 Press the key for "1 cup"
one cup, or the key for "2 cups"
make 2 cups.
The appliance now grinds the beans. In
the coffee-making process, the ground
coffee is first of all wetted with a small
quantity of water for pre-brewing. Fol-
lowing a short pause, the actual brew-
ing process commences. The coffee is
dispensed into the cup and the display
shows in the upper line the selected
cup size, and in the lower line an
advancing progress bar with a percent-
age indication
«
Once the progress bar is complete, the
desired quantity of coffee has also
been dispensed. The appliance auto-
matically stops delivering the coffee
and ejects the grounds into the waste
coffee container.
0 You can stop the delivery of coffee
prematurely at any time, by briefly
pressing the key that was previously
selected, or by turning the knob for
"Cup size" (Fig. 13) anti-clockwise
towards the "Espresso cup" position.
0 As soon as delivery is complete, to
3
3
to make
to
3
3
40%».
3
increase the quantity of coffee, simply
press and hold the key for "1 cup"
until the desired quantity is reached
(this operation must be performed
immediately after the the progress bar
shows 100%), or by turning the knob
for "Cup size" (Fig. 13) clockwise
towards the "Mug" position.
After a few seconds, the appliance is
ready for use again and you can make
another coffee. The display shows the
last coffee setting that was selected.
If the coffee is delivered a drop at a
time or not at all, or the coffee is deliv-
ered too fast and is not creamy
enough, you should change the grind-
ing setting; see „Setting the grinding
texture", page 46.
If the message «GROUND TOO
FINE ADJUST MILL
AND TURN KNOB» is displayed, the
coffee is ground too fine. You should
change the grinding setting; see „Set-
ting the grinding texture", page 46.
If the display shows: «FILL TANK»
the water tank must be refilled or the
appliance will not make coffee. (It is
normal for there still to be some water
left in the tank when the message is
displayed).
If the display shows: «EMPTY
WASTE COFFEE CONTAINER»
the waste coffee container is full and
must be emptied and cleaned; see
„Emptying the waste coffee container",
page 50. Until the waste coffee con-
tainer has been cleaned, the appliance
continues to display the message and
cannot make coffee.
Never remove the water tank whilst
the machine is delivering coffee. If it is
removed, the appliance will not be able
to make any more coffee. To vent the
appliance, turn the knob for steam and
hot water anticlockwise as far as it will
go, to the setting, and run off
g
41