AEG Electrolux CG 6600 Gebrauchsanweisung Seite 40

g
• Warning! Risk of scalding when hot
water nozzle or milk dispenser is acti-
vated! Escaping hot water or hot
steam can lead to scalding. Only use
the hot water nozzle or milk dis-
penser whilst holding a receptacle
underneath.
• Do not heat flammable liquids with
steam!
• Only operate the appliance when there
is water in the system! Only fill the
water tank with cold water, not hot
water, milk or other liquids. Take note
of the max. filling quantity of approx.
1.8 litres.
• Do not put frozen or caramelised cof-
fee beans into the bean container,
only roasted coffee beans! Remove
foreign bodies from the coffee beans.
Otherwise no guarantee can be given.
• Only put ground coffee in the ground
coffee slot.
• Do not leave the appliance switched on
unnecessarily.
• Do not subject appliance to the outside
elements.
• When using an extension lead, only use
a conventional lead with a cable diam-
eter of at least 1.5 mm
• Persons with motor difficulties should
never use the appliance without an
accompanying person in order to pre-
vent any hazard.
• Only operate the appliance when the
drip tray, waste coffee container and
drip tray grill are in place!
40
2
.
Safety when cleaning and
servicing
• Take note of cleaning and descaling
advice.
• Switch off appliance and pull plug out
before cleaning and maintenance
work!
• Do not immerse appliance in water.
• Do not clean appliance parts in dish-
washer.
• Never put water into the mill mecha-
nism, as this will damage the mill
mechanism.
Do not try to open up the appliance or
repair it. Unprofessional repair work
can lead to considerable danger to the
user.
Repairs to electrical appliances must
only be carried out by professionals.
In case of any necessary repair work,
including replacing the power lead,
please consult
• the dealer where you purchased the
appliance, or
• the AEG/Electrolux helpline.
If the appliance is used incorrectly or
for other purposes, no liability or
guarantee can be assumed if any
damage occurs - this also applies if
the descaling procedure is not carried
out immediately after the display
shows «PLEASE DESCALE !» and
is done in accordance with this
instruction manual.