Setting The Colour System; Displaying The On-Screen Indications - Sony KV-14V5D Bedienungsanleitung

ON
TIMER
SLEEP
SHOW VIEW
1
TIMER
ON SCREEN
4
TIMER REC
ON/OFF
7
TIMER REC
CLEAR
-/--
QUICK
REC
TIMER
REPLAY
INDEX SEARCH
REW
Note
The tape operation mode will be
displayed whenever you change the
mode (even when the
off.)
Downloaded from www.Manualslib.com

Setting the colour system

Normally, you will want to leave the colour system on AUTO. However, if
you notice streaks appearing on the screen during playback, you may
want to set the colour system to the system that the tape was recorded in.
MENU 1
Press MENU.
The main menu appears.
OK
2
Using the + ◊ or – √ buttons, move the cursor (z) to "VCR MODE," then
2 3
press OK.
5 6
VCR MODE
8 9
TRACK I NG CONTROL
OPC :
AUTO REPEAT : OFF
FORMAT :
0 C
COL SYS :
PROGR
S e l e c t
3
Using the + ◊ or – √ buttons, move the cursor (z) to "COL SYS," then
TAPE COUNTER
press OK.
SPEED RESET
PAUSE
4
Press the + ◊ or – √ buttons until the corresponding colour system appears
(PAL or NTSC), then press OK.
FF
PLAY
VCR MODE
TRACK I NG CONTROL
STOP
OPC :
AUTO REPEAT : OFF
FORMAT :
COL SYS :
S e l e c t
5
Press MENU to return to the original screen.
Displaying the on-screen
indications
Press
amount of tape remaining and linear tape counter on the screen, press
is turned
again.
To make the indications disappear, press
manuals search engine
ON
NORMAL
AUTO
a n d p r e s s
OK
ON
NORMAL
P A L
a n d p r e s s
OK
to display the following on-screen information. To show only the
Amount of tape remaining
Beginning of the tape
S
S
4 . 1 2 THU
2 0 : 0 0 2 : 0 5 : 1 0
Current date and time
Linear tape counter
until no indications appear.
End of the tape
E
Tape operation mode
E
Basic Operations
GB
25