Bios Overview; Accessing Thin Client Bios Settings - Dell Wyse 3040 Thin Client Benutzerhandbuch

Identifier
Version
Status
This section describes how to enter the BIOS settings/System Setup and configure the BIOS options of your thin client.
Themen:
•

Accessing thin client BIOS settings

• System Setup overview
• Boot Sequence
• Navigationstasten
• General screen options
• System Configuration screen options
• Security screen options
• Secure Boot screen options
• Performance screen options
• Power Management screen options
• POST Behavior screen options
• Virtualization support screen options
• Maintenance screen options
• System Log screen options
• Updating the BIOS
Identifier
Version
Status
Accessing thin client BIOS settings
This section describes about the Wyse 3040 thin client UEFI BIOS settings. While starting a thin client, a Dell logo is displayed for a short
period.
1. During the start-up, press the F2 key. and the default password is Fireport
2. The BIOS setting is protected by a password. When promoted, enter the password Fireport.
The BIOS settings dialog box is displayed.
3. Use the System Setup settings to change the BIOS settings.
ANMERKUNG: There is an option to restore BIOS defaults, Factory Defaults, and Custom user settings for Users in
BIOS menu. BIOS default setting restores the values that was part of BIOS file and, Restoring Custom User setting
restores to the default settings. Restoring Factory default restores the BIOS setting to the values that was
configured in factory before shipping the client.
To access the boot menu, during the start-up, press the F12 key. Use the boot selection menu to select or view the boot sequence order
as follows:
• Boot from UEFI: Hard Drive, Partition 2 (for ThinLinux clients), Partition 4 (for ThinOS clients)—Boots from the internal eMMC
storage.
• Boot from IP4 Realtek PCIe GBE Family Controller—Boots from the network through PXE.
• Boot from IP6 Realtek PCIe GBE Family Controller—Boots from the network through PXE
• Boot from USB—Boots the USB storage from any of the USB ports. This option is displayed if bootable USB devices are plugged in.
GUID-9A07C1F6-C8E3-4F96-AB82-ABFDD2FB0D7C
1
In translation
GUID-5D66971C-8E36-4FA1-9448-9FE6BE9A5D64
2
In translation

BIOS overview

BIOS overview
8
57