Connecting To A Compressed Air Source; Use - Parkside PDBNP 14 B1 Originalbetriebsanleitung

♦ Manually add 3–5 drops of pneumatic oil from
the supplied oil container
nipple after every 15 minutes of operation .
♦ When opening the oil container
time, remove the cap nut from the container .
Use a pair of long-nosed pliers or a similar
implement to remove the internal pipette .
♦ Turn it 180°, replace it and screw it back in
place with the cap nut .
♦ Use a needle or similar tool to poke a small
hole into the tip of the pipette to release oil .
Connecting to a compressed air
source
NOTE
► Before connecting the compressed air source,
–
the correct working pressure (3–6 bar)
must be fully reached
–
ensure that the trigger
♦ Pull the supply hose connector over the quick-re-
lease fastener on the connecting nipple
it clicks into place .
NOTE
The compressed air source must be equipped with
a pressure reducer to ensure that you can regulate
the air pressure .

Use

♦ The appliance is ready for use as soon as the
pneumatic air flow has been established .
♦ Screw the pin collector
the pin collector
♦ Determine the suitable rivet size on the basis of
the workpieces used .
♦ Use a suitable tool to drill a hole into the work-
pieces in the spot where the rivet
located . Make sure the diameter of the hole
corresponds to the determined rivet size .
■ 20 │ GB │ MT
into the connecting
for the first
is not pulled
onto the thread for
at the back of the machine .
will be
CAUTION!
► Suitable safety precautions must be taken
depending on the size and nature of the
workpieces . Use suitable clamping devices to
prevent the workpieces from slipping .
► In the event of an interruption to the air sup-
ply, release the trigger
► Before switching on the machine, make sure
the machine tool is firmly placed on the
surface to be processed .
♦ Check if the diameter of the attached mouth-
piece matches the mandrel diameter of the
determined rivet size .
♦ If it does not, unscrew the front connector
using the assembly spanner
CAUTION!
► Ensure that the appliance is disconnected
from the compressed air source before you fit
or remove the front connector
♦ If necessary, unscrew the mouthpiece
until
the front connector
ner . Afterwards, screw the correct spare
mouthpiece
tighten it .
♦ To attach the front connector
the thread (you will feel minor resistance) and
tighten it by hand .
♦ Tighten the front connector
bly spanner
♦ Reconnect the appliance to the compressed air
supply .
♦ Place the rivet body in the drill hole .
♦ Slide the appliance over the rivet
mandrel is fully inserted into the mouthpiece
♦ Pull the trigger
the device, detached from the rivet body and
the rivet joint is established permanently .
If necessary, repeat the process until the man-
drel has been fully separated from the rivet
body .
NOTE
You will need to tip the appliance to the rear to
get the mandrel into the waste collector
immediately .
, if necessary .
.
using the assembly span-
into the front connector
, press it onto
using the assem-
.
until the
. The mandrel is pulled into
PDBNP 14 B1
from
and
.
.