Intended Use; Features; Scope Of Delivery; Technical Data - Parkside PFMR 1400 B1 Bedienungs- Und Sicherheitshinweise

Introduction
Paint & mortar mixer
PFMR 1400 B1
Introduction
Congratulations on your purchase. You have selec-
ted a high quality product. The instructions for use
are a part of this product. They contain important
information about safety, use and disposal. Before
using the product, please familiarise yourself with all
the operating and safety instructions. When passing
this product on to others please be sure to also in-
clude all of its documentation.

Intended use

The machine is intended for mixing building materi-
als that are in a fluid or powder form, e.g. paint,
mortar, adhesives, plaster and similar substances.
Depending on the consistency of the material and
the amount to be mixed, the appropriate agitator
with the suitable mixing effect should be used. The
machine may only be utilised for its intended use.
Any other use is not intended. The user / operator,
not the manufacturer, is liable for resulting damages
or any type of injury resulting from any other use that
is not intended. Please note that our devices were
not constructed for commercial, manual, or industrial
use. We do not accept any warranty liability if the
device is used for commercial, manual, or industrial
operations, or activities similiar to these.

Features

Handle
1
Open-end spanner for changing agitator
2
Agitator shaft with M-14 inner threading
3
Hold-to-run button
4
ON / OFF switch
5
Mixing paddle
6
Mixing spiral
6 a
Shaft
6 b
Support bracket
7
6 GB

Scope of delivery

1 Paint & mortar mixer PFMR 1400 B1
1 Mixing paddle
2 Open-end spanners for changing agitator
1 Support bracket
4 Crosshead screws
1 Instructions for use

Technical Data

Mains voltage: 230 V∼ 50 Hz
Power input: 1400 W
Idle speed: 0–700 min
Mixer holder: M14
Protection class: II /
Weight without
mixing paddle: 3590 kg
Noise and vibration data:
Values for noise determined in accordance with
EN 60745. The A-weighted noise levels of the
electrical power tool are typically:
Sound pressure level: 90.3 dB(A)
Sound power level: 101.3 dB(A)
Instability K: 3 dB
Wear hearing protection!
The total vibration (vector sum of three directions) is
calculated in accordance with EN 60745:
Vibration emission value a
Uncertainty K = 1.5 m / s
The vibration level specified in
these instructions was measured in accordance with
an EN 60745 standardised measurement process
and can be used to compare equipment. The vibra-
tion emission value specified can also serve as a
preliminary assessment of the exposure.
The vibration level will change according to the ap-
plication of the electrical tool and in some cases,
may exceed the value specified in these instructions.
Regularly using the electric tool in such a way may
make it easy to underestimate the vibration.
-1
= 1.570 m / s ,
2
h
2