Trouble Shooting; Fault Correction - Parkside PAS 900 A1 Originalbetriebsanleitung

GB

Trouble shooting

Problem
Device does not start
Low or lack of suction
12
Possible cause
Mains voltage is not present
The equipment is not
switched on
Safety stop due to missing
or incorrectly inserted pleat-
ed filter ( 13) or metal
filter cage ( 14)
Defective on/off switch
( 6)
Defective motor
The single-use thermal fuse
has disconnected the power
circuit
Suction hose ( 11) or suc-
tion tube ( 12) blocked
The metal container (
is not closed
The metal container (
is full
The pleated filter (
clogged
The air filter ( 18) is
clogged
Pre-filter ( 15) is clogged
Pre-filter ( 15) reduces
the suction power

Fault correction

Check plug socket, power cord,
line, plug and fuse, where ap-
propriate, repair through electri-
cal specialist
Switch on the equipment (see
"Switching on/off")
Insert the pleated filter correctly
(see "Cleaning/Maintenance")
Repair through customer service
Remove obstructions and block-
ages
10)
Close the metal container
10) Empty the metal container (see
"Cleaning/Maintenance")
Clean or replace the pleated
13) is
filter (see "cleaning/mainte-
nance")
Clean the air filter (see "Clean-
ing/Maintenance")
Clean or replace pre-filter (see
"Cleaning/Maintenance")
To vacuum coarse dirt, remove
the pre-filter