Working Without The Automatic Levelling System; Practical Guidance; Working With The Clamp - Parkside PKLL 7 C3 Originalbetriebsanleitung

Working without the automatic
levelling system
Put the LOCK switch
Push the ring-button
product will release two laser lines from the laser beam open-
ing that are not levelled. Operation without automatic lev-
6
elling will always be indicated via the red LED indicator
Push the ring-button
this mode.

Practical guidance

Always use only the middle of the laser line for markings. The
width of the line depends on the distance.

Working with the clamp

The clamp provided can be used to attach the device to various
objects.
1. Release the clamping nut
clockwise.
2. Position the clamping jaws
3. Rotate the clamping nut
4. Place -thread
the clamp and tighten with hand. Do not use excessive force
as this may damage the device.
16 GB
into the position .
4
on the top of the product. Now the
1
on top again to turn off the product at
1
by rotating the clamping nut anti-
10
to the desired location.
9
clockwise until fastened.
10
of cross line laser with the
5
.
2
-screw of
7