Using The Control Panel Power Switch (Sleep Mode) - Canon imageRUNNER serie Anwenderhandbuch

8
9
NOTE
After restarting the machine, you might want to check if the IP address is correctly set
to the machine. For help, see "Connecting the Machine to a TCP/IP Network" in the
e-Manual.

Using the Control Panel Power Switch (Sleep Mode)

Control Panel Power Switch
To turn the control panel ON or OFF, press
the control panel power switch. When the
control panel is turned OFF, the machine is
in the Sleep mode.
ON
OFF
Press [OK] to finish the initial
setup.
From the next time the machine's main
power is turned ON, the Setup Guide does
not appear.
If you want to return to the previous screen,
press [Back].
Press [Yes] to restart the
machine.
If the IP address settings have been
specified, restart the machine to make the
settings effective. Press [No] if you want to
manually restart the machine later. (See
"Restarting the Machine," on p. 6-12.)
NOTE
• The machine will not enter the Sleep mode
when it is in operation.
• The machine can receive, forward, or print
documents when it is in the Sleep mode.
Machine Status
Ready
Sleep mode
Turning ON/OFF the Machine
2
2-11