Mowox RM 30 Li Originalbetriebsanweisung Seite 64

Now place your robot into the working area, next to the charging station.
A green flashing LED on the base station indicates wrong
Press the main power switch to "ON".
Now press the power soft button
After a short boot of the operating system,
enter the PIN code "1234" as follows:
Confirm with
again .
Rev 19
installation of the boundary wire.
.
, press and then
warranty.
OFF (Released)
.
Now your mower should follow the
wire in an anti-clockwise direction and
dock into t h e charging position. The
mower will start to fully charge. If
robot misses to dock, you might have
to adjust the charging station sideways
until the robot docks without any
problem.
21 (EN)
ON (Pressed)