Removing The Universal Stirrer; Operation; Switching On/Off (See Fig . E); Soft-Start Function - Parkside PFMR 1600 B2 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung

˜ Removing the universal
stirrer
Removing the universal stirrer 4 from the
¾
agitator shaft 3 : Use the assembly spanners
2 per rotational direction of
reverse steps of "Fitting the universal stirrer"
mentioned above) .
˜ Operation
˜ Switching on/off (see Fig. E)
Switching on:
Press and hold the lock-off button 6 . Then,
¾
press the ON/OFF switch 5 and hold it in
position .
Switching off:
Release the ON/OFF switch 5 .
¾
˜ Soft-start function
This product has electronically controlled
¾
soft start function which enables the product
starting up smoothly to avoid "kick-back" .
This function enhances safety and also
prevents the materials to be mixed from
spurting out of the mixing container .
˜ Setting the speed by ON/OFF
switch (see Fig. E)
NOTE
Adjust the speed setting by varying the
u
contact pressure on the ON/OFF switch .
The speed setting can be changed during
u

operation .

14 GB
Press and hold the lock-off button 6 . Then,
¾
press the ON/OFF switch 5 lightly for a
low speed .
Increase the pressure to increase the speed .
¾
(follow the
˜ Speed pre-selection
(see Fig. F)
The product's mixing speed can be adjusted to
different viscosities .
Before you start working: Adjust the
¾
rotational speed according to the viscosity of
materials to be mixed:
NOTE
The universal stirrer 4 moves for a short
u
while after the product has been switched
off . Do not put aside the product until it
comes to a complete stop .
Always start from lowest speed setting .
u
Then increase the pre-selected speed until
the best mixing effect is achieved .
˜ Working with the mixer
Dip the universal stirrer 4 into the material
¾
you want to mix at a low speed .
Once the spiral 4a is completely immersed in
¾
the material you can increase the speed .
During mixing, move the universal stirrer 4
¾
through the mixing container and continue
mixing until the material is thoroughly mixed .
Speed control
button
Increase speed
7
8 Decrease speed
Rotational
speed