Replacing the diamond cutting discs
(see Figures A - F)
NOTE
►
Replace diamond cutting discs only in pairs.
♦
Loosen the locking screw
♦
Push the depth stop
♦
Press the spindle lock
♦
Use the face spanner
flange
.
♦
Take off all removable parts from the spindle.
♦
Clean the locking flange
and backing flange
♦
Attach the backing flange
NOTE
►
Make sure that the backing flange
correctly attached by ensuring that it rotates
together with the spindle.
♦
Attach the first diamond cutting disc (see
Fig. B).
♦
Set the desired cut width in accordance with
the number of blotters
is set in place as the top blotter (see Fig. C
and F).
♦
Attach the second diamond cutting disc
(see Fig. D).
NOTE
►
Make sure that the cutting discs are correctly
attached to the flanges.
♦
Tighten the locking flange
spanner
. Press the spindle lock
doing this (see Fig. E).
│
■
8
GB
.
upwards.
and hold it down.
to loosen the locking
, flange
, blotters
thoroughly.
(see Fig. A).
is
. Ensure that the flange
using the face
while
Setting the groove depth
♦
Loosen the locking screw
♦
Set the depth stop
♦
Tighten the locking screw
Attaching the dust extraction adapter
♦
Push the pins of the dust extraction adapter
into the recesses on the dust extraction connector.
♦
Lock the dust extraction adapter
♦
Loosen the union nut
♦
Push the pipe of the extraction device far enough
into the opening on the union nut
♦
Tighten the union nut
Operation
Switching on and off
NOTE
►
Always switch the appliance on before making
contact with the material, then apply it to the
workpiece. The wall grinder is equipped with
an electronic smooth start. The motor starts
with a delay.
Switching the appliance on:
♦
Activate the safety lock-out
page). Then press the ON/OFF switch
Switching the appliance off:
♦
Release the ON/OFF switch
.
to the desired depth.
.
by turning it.
.
.
fully.
(see fold-out
.
.
PMNF 1350 B2