Connecting Control Cords; About Sr; Watching An Image From A Personal Computer; Connecting A Personal Computer - Pioneer PDP-505XDE Bedienungsanleitung

12 Enjoying through External Equipment

Connecting control cords

Connect control cords between the Media Receiver and other
PIONEER equipment having the
operate the connected equipment by sending commands
from its remote control unit to the remote control sensor on
the Media Receiver.
After the CONTROL IN terminals have been connected, the
remote control sensors on the connected equipment do not
accept commands from the remote control units. Face the
remote control units to the remote control sensor on the
Plasma Display when operating the connected equipment.
• Make sure that the power is turned off when making
connections.
• Complete all component connections before making
control cord connections.

About SR+

The CONTROL OUT terminal on the rear of the Media Re-
ceiver supports SR+ that allows linked operations with a
PIONEER AV receiver. SR+ presents functions such as the
input switch linkage operation function and the DSP sur-
round mode display function. For more information, see the
instruction manual that came with the PIONEER AV receiver
supporting SR+.
• While in connection through SR+, the volume on this
system is temporarily minimised.
Media Receiver (rear view)
ANT
(DIGITAL)
OUT
I N
SERVICE ONLY
CONTROL
INPUT 1
i / o link.A
SELECT
INPUT
2 3
INPUT 2
OUT
I N
CONTROL
The control cables (commercially
available) are monaural cables with
mini plugs (no resistance).
48
En
logo. You can then
DIGITAL OUT
OPTICAL
OUT IN
COMMON INTERFACE
SUB WOOFER INPUT 2
OUTPUT
COMPONENT VIDEO
Y P P
B R
MONITOR
OUTPUT
HDMI
VIDEO R-AUDIO-L INPUT 3
INPUT 3 S- VIDEO
CONTROL
IN
OUT
CONTROL
IN
OUT
CONTROL
IN
OUT
Watching an image from a personal
computer

Connecting a personal computer

Use the PC terminals to connect a personal computer.
• The PC input terminals are DDC2B-compatible.
Media Receiver (front view)
ø 3.5 mm stereo mini-plug
cable (commercially available)
AC IN
BLACK
Displaying an image from a personal com-
WHITE
SYSTEM CABLE
puter
To watch an image coming from the personal computer, press
PC on the remote control unit or press INPUT on the
Plasma Display to select "PC".
When connecting to a personal computer, the correct input
signal type is automatically detected. If the personal com-
puter image does not come in clearly, you may need to use
Auto Setup menu. See page 38.
• The PC terminals cannot be used for audiovisual equip-
ment.
RGB cable
(commercially
available)
Personal computer