Preparation; Installing The Plasma Display; Installing The Media Receiver - Pioneer PDP-505XDE Bedienungsanleitung

Preparation

Installing the Plasma Display

Over 50 cm
Over
10 cm
Location
• Avoid direct sunlight. Maintain adequate ventilation.
• The length of the system cable used to connect the Plasma
Display and the Media Receiver is about 3 m.
• Because the Plasma Display is heavy, be sure to have
someone help you when moving it.
• If you place anything on the top of the Media Receiver it will
not receive enough ventilation and will not operate properly.
• Allow enough space around the upper and back parts when
installing to ensure adequate ventilation of the rear of the
unit.
Using the optional PIONEER stand
• For details on installation, refer to the instruction manual
provided with the stand.
Using the optional PIONEER speakers
• For details on installation, refer to the instruction manual
provided with the speaker.
Operating Environment
Operating environment temperature and humidity: +0°C to
+40°C; less than 85% RH (cooling vents not blocked)
Avoid installing in the following locations:
• Under direct exposure to sunlight
• Under strong artificial light
• In high humidity
• Poorly ventilated

Installing the Media Receiver

Plasma Display
System cable
(approx. 3 metres)
• Do not place a VCR or any other device on top of the
Media Receiver.
• When installing, allow enough space on the sides and
above the Media Receiver.
• Do not block the side cooling vents or the rear ventila-
tion fan opening of the Media Receiver.
Over 5 cm
Over 5 cm
Over 5 cm Over 5 cm
Media Receiver
(vertical installation)
(horizontal installation)
Over 5 cm
Over 5 cm
Over 10 cm
Over 10 cm
06
15
En