Reel Assembly; Folded Filter Assembly; Suction Hose Assembly; Switching On/Off - Parkside PAS 1200 C2 Originalbetriebsanleitung

Reel assembly

Clip the three reels (
edge of the housing onto the relevant cur-
vatures. The curvatures are located on the
bottom of the housing

Folded filter assembly

The metal folded filter (18) is alrea-
dy pre-assembled before initial use.
1. Place the folded filter (18) on the inver-
ted container cover (10).
2. Screw in the folded filter (18) tightly in
a clockwise direction.
The folded filter (16)
must rest on the con-
tainer cover (10).
Then press down the
switch of the safety switch (19).
The arrow on the folded filter (18) must
be at the same height as the arrow on
the label of the container cover (10).
If the safety switch (19) is not
pressed down, the appliance can-
not be started.
If the folded filter (18) is rotated
further, as the arrow mark on the label
indicates, the folded filter can firmly
suction to the container cover (10).
C D
3. Place the container cover (10)
on the metal container (13) and
lock it with the locking clips (9).
M N O
When fitting the container cover
(10), you must ensure that the on/
W X Y
off switch (
nection (11) are roughly aligned to
each other or the container cover
cannot be put on correctly.
14) at the lower
E F G
P Q
Z
8) and the hose con-

Suction hose assembly

1. Connect the suction hose (15).
To do this, insert the rotatable plastic
end piece (with the printed symbol)
into the hose connection (11) and
screw it tight (bayonet connection).
If correctly installed, the symbol on
the suction hose (15) points upwards.
When assembling/detaching the
suction hose (15), hold the black
plastic end piece and not the suc-
tion hose (15). Twisting or bending
could damage the hose.
Suction tube:
Plug the suction tube (16) onto the rigid
end piece of the suction hose (15).
19
Crevice nozzle:
Place the crevice nozzle (17) on the rigid
end piece of the suction hose (15).
Suction tube and crevice nozzle:
Place the crevice nozzle (17) on the suc-
tion tube (16) and place this on the rigid
end piece of the suction hose (15).

Switching on/off

Connect the mains plug.
H I
The appliance is equipped with a
safety switch (
operation only if the folded
R S
filter (
Switching On:
On/Off Switch (see
Switching Off:
On/Off Switch (see
GB
J
19) that permits
T
18) is fitted correctly.
8) In position "I"
8) In position "0"
MT
35