Körperschallwandler Diese Anleitung richtet sich an Installateure von Beschallungs- anlagen mit entsprechenden Fachkenntnissen. Bitte lesen Sie diese Anleitung vor der Installation gründlich durch und heben Sie sie für ein späteres Nachlesen auf. Verwendungsmöglichkeiten Dieser Körperschallwandler (Exciter) wird auf eine schwing- fähige Fläche geklebt (z.
1) Vor der endgültigen Montage einen Probebetrieb durchfüh- ren, um die für den Klang optimale Position zu ermitteln. 2) Zur Montage den EX-1W nach Entfernen der Schutzfolie auf eine saubere, ebene Fläche kleben. 3) Den Verstärker vor dem Anschluss ausschalten.
Exciter These instructions are intended for installers of PA system with adequate technical knowledge. Please read the instructions carefully prior to installation and keep them for later reference. Applications This exciter is glued onto a surface capable of vibrating (e. g. table plate, shelf, bathtub, shower enclosure, ceiling panel or glass pane) so that the surface serves as a kind of speaker cone.
Seite 6
3) Switch off the amplifier prior to connecting the exciter. 4) Connect the cable of EX-1W to a speaker output of the amplifier. When connecting multiple exciters to a single output, make sure that they have the same polarity and are not below the minimum load imped- ance of the output.